systems

Ceilings, frame walls, and stem walls are always an option for plumbing and electrical locations. When you do have to run these systems through a bale wall, how do you do it?

Plumbing leaks are more critical within straw bale walls than within stick frame walls for obvious reasons: straw rots pretty quickly if it gets wet and stays wet - a lot quicker than 2×4s would rot. As a precaution, it is best to keep most of the plumbing within interior walls and run the water into the house through a stem wall. The highest standards of fitting can help minimize the risk of leaks. Careful planning eliminates unsightly messes at this point. Before beginning construction, you should plan for water to enter where pipes will not be seen in plain view, such as under a sink or in a mechanical closet. Use of the stem wall is appropriate for running water into your structure.

The electrical system in a bale home is the same as in a stick frame home from the circuit breaker to the switches and fixtures. However, electrical wiring has different installation methods in a straw bale wall. UF (Underground Feeder) cable is recommended for its durability and moisture resistance. A metal “needle” is used to thread the wire from the exterior to the interior where necessary. A chainsaw is used to cut a 1.5 inch channel in the straw bale walls. The wire is stuffed into the channel or in the seam between bales and run to switch and fixture locations. Plug and switch boxes are screwed to a wooden stake which is driven into the bale to keep the box in place.

This post was submitted by ThinkDwell. Visit Our Blog.